Iwannagofishin
Removed all my boat hull zincs and a couple of outboard zincs and cleaned them up. Lots of powder buildup that cleaned off easy. One thing though, the screws that hold them were seized up and a bitch to loosen/remove, but got them out without breaking any off, which leads to a question. I am going to grease the threads w/ some anti-seize before re-installing. A marine grade is available, but read something about a copper based anti-seize may be better? Also, would it be a good idea to put a thin coat of inhibitor between the zinc and hull contact point? I work in the electric utility industry and we place inhibitor on all connections for best conductivity. Thanks.