RT:

Thanks for the skinny on the Wind.

After reading this post on bobbers I went out and grabbed a cork float and some black surgical tube.

I came up with a variation of what you and Hawk were describing that will work on the cork floats you like.

Run your main through two small pieces of tube. Snip a small section off the top of the plastic cones. Just enough to lessen the diameter so you can fit surgical tube over it. Not too much or you wont have enough for the tube to grab. Insert the cones into the bobber just enough to snug, leaving
half the cone sticking out. Slip the tube over the cones, the same way the old schoolers do with pencil lead.

Big Stew and I are going down the Wilson on Sat. Ill let you know how the bobber rig works.