Here's my G19-size P80...




Non-OEM parts :
Polymer 80 frame
Brownells slide
KKM barrel
Overwatch TAC trigger
Wolff RP safety plunger spring
LWD safety plunger
LWD channel liner
Wolff 4lb striker spring
DelTac trapezoid slide lock lever
Steel City magwell....made for the P80 G19....not adapted


Noteworthy parts :
Standard length OEM mag catch (extended not needed on this frame)
OEM "Dot" connector (performance similar to OEM "Minus" connector)
OEM 5lb trigger spring (why mess with success)
OEM standard slide stop lever (like)
OEM RSA (requires less clearance)

Trigger performance :
Reduced reach (LOP)
Very short take-up
Defined wall
Average pull weight is 2lb - 4oz
Very short reset
I like it there for a range gun, but I would bump it up to 4lb+ for a SD gun

ETA:
These are 80% complete frames and are shipped to your mailbox.
You mill/cut four tabs on the top of the frame, cut out a bulkhead inside the frame and drill 3 (6) holes.
_________________________
NO STEP ON SNEK