jet boat anchors

Looking for anchor system for my north river jet boat, I like the systems that I have seen on other jet boats. so far I have only found one place to buy one and they are very proud of it!!!

Expect to pay up to 125 (maybe more)for the whole shootin match. that should be 300ft 3/8" anchor line, anchor with chain, and bouy with anchor puller.

I am just assuming that you are looking for the anchor puller setup thing for the columbia and that type of thing.

Yes they sure are proud of their ideas aren't they

For the rivers other than the Columbia you can get the "Anchor-Eze" setup for the bow of your boat, they will run around $175 and a can type anchor will run you around $75 - $90 depending on how heavy a one you get. I have a 65 lb for my sled. 100ft of 3/8 no stretch should be good for this set up. I picked up the puller at Woolridge in Seattle. If you want it welded on they will do it for an extra $25.
Good luck and tight lines, Jeff
Isn't that why they call it a hole in the water you through money into?!?!?!?!

The can-type anchor holder I switched to from the anchor-eze. The pulley on the anchor-eze that I had was plastic and I replaced it twice in six weeks. (though I had it for 3 years without a problem) The pulleys on the can-type are made of aluminum, so far I haven't had any problems with it. (bought it 9 months ago) Both work well, had a 45# anchor on the anchor-eze and a 55 pound on the can-type holder.

Paid 150.00 at Doug's in Woodinville. I would check with Three Rivers Marine for a price, I believe they went up to 199.00 right after I bought mine.

Good luck

Doubletake