Building your own pontoon boat?

I was thinking about trying to build my own Pontoon boat. Has anyone else done this? What materials did you use? Whered you get the pontoons. Thanks for any help.

Fun fishing
Josh

FLYGUY, I have seen alot of homemade pontoon boats on the Yakima. Most of them are framed with electrical conduit (metal), and I even saw one framed with glued P.V.C. As for the pontoons I never asked the guys where they got them, but I tried to buy a spare pontoon for my steelheader 9' and they were $300 +- each. Good luck.

I had these very same questions about 5 years ago,I'll make this short and sweet, tubes run between $300 and $700 each depending on size and material used .I make my own frames and a few for friends and such,drop me an e-mail I'll send you in the right direction thanks good luck
also check out the post titled cataraft or drift boat on this b.b.

------------------
Tight Lines
FISH ON ------<*)>><
Men are like fish we get into trouble when we open our mouths to much!!

[This message has been edited by Steelheader boy (edited 04-24-2000).]

Go to www.flyshop.com In the nw buletin board ask this question. I believe one of the guys(bubba) made one.