Originally Posted By: rvrfshr
.031 wire, using pliers for the bending.

A man of very, very few words, but dead on. The expensive spinner makers flat out stink. Get a good pair of thin needle nose.

 Originally Posted By: thaxor
Thanks for the links Vhawk, Pentac site is a little easier to navigate so I'll give them a try.

Just curious thaxor, if you admire rvrfshrs work (a board sponsor) like you said in your original post, why would you be ordering from Pentac? Prices? Quality of components? Customer service? 4.5 blades? Just wondering.

http://www.rvrfshr.com

Ike