Probably in the wrong forum, but since this is where I hang-out
on PP it seemed the right spot.

I have developed a new product, and need to find a good machinist
that can turn me out a couple of prototypes from alum. Very simple
item, really, but unfortunately after calling several shops in my area
I didn't find much interest. I'm more than willing to pay fair rates for
time and materials.

A component of the product will most likely remain an alum.
part, and qty. (once on the market) should be in the several
thousand pieces, monthly once it gets going.

Preferrably a shop in Snohomish/Skagit counties, but hell, at this point
if I can find a willing machinist that will take a few minutes and make
me one of these I would be willing to make the drive to them.

I do not have CAD drawings yet, as I don't have that capability. Doubt
it would take anyone very long who knows what their doing.

Suggestions welcome!

ISO