For several reasons, I'm committed to wrapping my own rods from here out. I've built a few spinning rods in my youth but haven't made anything since.

In looking around, there are a wide variety of rod wrapper and "rod wrapping systems". The very basic ones (which is similar to what I used years ago) are simple wood stands with a tension adjustable thread holder and cost $20 to $40. A low RPM drying motor is usally sold separately as is the rod chuck.

Then there are the higher-end complete kits for $200 to $300.

Does anyone have any positive or negative experiences with any particular models or have any advice when it comes to cobbling a cheaper one together or buying a diamond-encrusted Cadillac model that can give BJ's while I wrap?

-AP?