I use pipe wrap (1" size) cut into approx. 1 foot sections. I wrap these onto the pipe wrap starting with the top end of the leader and wrapping around until I get to the hooks, then bury the hooks into the wrap to secure. Then, the rolls can go onto a leader dispenser (even a paper towel holder would work). They roll off very nicely. I usually figure about 15 leaders per 1 ft. section. This is for a boat set-up. For the bank, I just cut my rolls down to about 4 inches, so they can fit into a pocket. I hate using PIPS leader dispensers because if you have more than a few long leaders, they seem to get tangled. No tangles with this method. Many of the guides I know use this method, as well.