Having some fun doing a little make over on a Ruger 10/22 (non breakdown) Tactical.
Would love to see what any of you have done to your 10/22's.
Start of the Project:
Factory OEM Ruger 10/22 Tactical model.
https://ruger.com/products/1022Tactical/models.htmlStep 1: Tore it down to every last part, including the removal of the barrel from the upper receiver.
Step 2. Replaced the OEM stock with a new Mag Pull Hunter X-22 stock.
https://www.magpul.com/products/hunter-x-22-stock-ruger-10-22Step 3. Replaced the barrel buffer with a new Kidd Innovative Design rubber buffer.
Step 4. Replaced the OEM bolt, charging handle, guide rod and spring with a new Kidd Innovative Design scalloped black bolt and new black bolt handle.
Step 5. Replaced the OEM threaded 16" tactical barrel with a new Kidd Innovated Design 20" black sand blasted fluted threaded bull barrel. Also replaced the OEM barrel V block with a Kidd V block.
Step 6. Removed the top OEM rail on the upper receiver and replaced it with a pair of Talley low profile 1" rings.
Step 7. Added on a Primary Arms PA6x32-22LR ACSS Reticle scope.
Step 8. Added a #10-32x3/8 swivel stud to the forearm of the new X-22 stock. Attached a Harris folding bipod to stock.
Photos to be added when all of the parts have arrived and are assembled.
Step 9. Assemble, shoot, zero, etc.
Step 10. Future Step - replace the modular trigger with either a Timney trigger or a Kidd Innovate Design Trigger. Haven't figured that one out yet.