Okay, I admit it: I've cut dink bobbers in half with PowerPro. Afetr I square the remnants off, is there a good way to reset the tubes in the float so that they stay put? How are these best glued? And: what sort of material might be used? Once, during a fit of desperation, I shoved a coffee creamer stirrer up my dink float as a guide for the line...just kept slipping out, though...

On that note, fishing just a 3" dink float over undisturbed water with just a few split shot can be surprising...where can I order these without buying the larger ones and trimming them to size?