SSF,

I refinished the outside of the boat two years ago, and replaced the bottom. This summer I'll start to refinish the inside, sand the outside, fill in the few nicks I put in her, and the hole (oops, but not too bad), and give it a fresh coat of paint.

My boat is an older ('84) Keith Steele boat. The front seat is adjustable, and I have many options. I have two fish-on sliders on pedastals that I can run together on the front seat section, or I can put one in front, and one in the back, if I have two fly fishers. I can also run just a plain bench with cushons for lake trips, as pictured here. I can also add two funky looking seat backs for use in conjuction with the bench cushion.

The front seat bench is adjustable along a galvanized pipe rail system, and removable by flipping up the wood latches. One latch can be seen in the lower right hand corner, next to the pipe clamp in this photo.

The rowers seat is fixed and is made of rope. It is actually quite comfortable with boxes on either side for gear storage.

Hope these help somewhat. What kind of bottom do you have on yours? UHMW or epoxy & Gluv-it?

Send me a PM if you need further help.