PenTac, RVRFSHR, MorTac, R&B, etc.

I get my parts through these guys. Great place to shop online!

http://www.barlowstackle.com/

I use whatever plain brass bodies I can find or from whomever has given me some to try out.

Set the oven to 300. Set a layer of foil on the bottom of the oven, as the coating will spill off the bodies as it melts.

Take a body and put it head up on a shaft and slightly bend the tip of the shaft so the body doesn't fall off.

Cook the bodies for 12 minutes.

Dip in your first coat of powder coat. Cook for 12 minutes. Bob likes to dip the first coat in white. I just stick with the same color.

Dip them again. Cook another 12 minutes.

Once you take them out of the oven, let them cool just enough so you don't ruin the coating, but work fast to get the shaft out of the body....as it will be coated solid. Takes some prying and spinning.

Use a very small drill bit to bore out the melted power coat in the butt section of the body.

PITA....and a labor of love, but my kids call it "Daddy Crafts".

All the credit for these spinners goes to Bob and Corey.