I am looking for a still in good quality GL2 or 3 rod. 1- 6 oz lure weight. 8+ feet length. And would like if the person could wait awhile(with rod) so I can get some money. Thanks,

------------------
To Hell with the Antis!

C.D

I build custom rods I can build you a GL2 HSR1025 8'6" 15-30 1-6oz cosiderably lower price then loomis would charge.It would have the same warranty and you can have it built exactly the way you want.Let me know and we can work out an exact price.Thanks Kevin

Kevin,

That would be great!, heres a list of specifications,

8'to 9' length
1-6 oz lure weight
15 minimum line weight
Cork handle
Fuji or Shimano Guides

let me know the possible price, and I'll let you know if I can do it. Thanks again!




------------------
To Hell with the Antis!

C.D

Did you want casting or spinning?How long you want your rear cork and what type of reel so I know how long the reel seat has to be.K

[This message has been edited by b-bouncer (edited 06-05-2000).]

probably about a 12" rear cork section. And if possible a 3 1/2 or 4 inch front cork area. It would have eaither a SHimano Corsair or a Shimano Bantam 50. Probably a reel seat area of 3 1/2 to 4 inch, it would be for a baitcaster reel

------------------
To Hell with the Antis!

C.D

I can make that rod for you for 140.00 plus shipping.If that wont work Let me know I can get some loomis overstock blanks with no warranty and cut about 40.00 off of that.K

Sounds pretty good to me, $140 is great!. How long would it take to make the rod?. Like I said it may take me a couple of weeks to get the money.

------------------
To Hell with the Antis!

C.D

I ordered the blank today it will take a few days to get it. As soon as it is received it will only be a few days but I can wait a while for the money.email me and give me your email so we can keep in contact and close this thread.Thanks

fshmn101@cs.com