Been getting a lot of line fray when float fishing from what I assume would be the line sliding back and forth through the float while I'm fishing. Some floats it seems to happen worse than others but currently I've just been using Aerofloats with the metal grommets on the end and I'm wondering if those are the main culprit.

I know an alternative would be to use a mono topshot or just cut off the section thats fraying but I prefer to go braid the inline sinker. I doublt I'll be able to fully eliminate this fraying process but I'd like to at least slow it down. So far the best idea I've come up with is to sand down the inside of the grommet with say 2000 grit sand paper. Other than that I should maybe just switch to an all plastic float or something.

Interested to hear if y'all experience this problem and what could be done about it.