Here's a tip for all you plunkers out there.

To make your spin-n-glo's spin effortlessly in slow current you need to buy a box of Plastic (not paper) shafted "Q-tips".

First Drill out the hole in the spin-n-glo just slightly larger than the diameter of the "Q-tip" shaft. Then cut the hollow q-tip shaft to the length of the spin-n-glo. Then dab a little epoxy on the outside of the q-tip shaft and insert it into the pre-drilled spin-n-glo. You will have an effortlessly spinning lure. This will also reduce line wear if you're fishing in heavy current. Be sure to use a bead or Corky as a bearing.

Good Luck

Aaron